Lab Document: Extraction of MOSFET Parameters using 4007 Array

My PDF Solution – Warning Will Robinson:  I never get 100% correct!

The following two measurements are where the MOSFET is in saturation and use the 8if method to nd ISpecific. In this
case because we are looking into the MOSFET source circuit we do not have to worry about slope factor n: Simply go to the
point where gms/ID=20 and read o the current the divide by 8 to arrive at the specic current.

Part_01_Vg_2_Vd_5Part_1_Source_Drive

Vgate = 2:0 VD = 5 : Ispecific = 0:735 uAmp

Part_01_Vg_1p7_Vds_5VPart_1_Source_Drive

Vgate = 1:7 Nominal Vt VD = 5 : ISpecific = 0:92 uAmp

The triode region determination of specic current is a little more complicated. I used Vds=15mVolts which results in if = 3
and ir = 2 which is convenient in the last part of the calculation of specic current.

Part_01_Vg_2_Vds_p015Part_1_Source_Drive

Part_01_Vg_1p7_Vds_p015Part_1_Source_Drive

Unabiguous-Extraction-Vt_IfUnAmbiguous-Parameter-Circuit

Vt_vs_Vs

n_vs_Vs       


0 Comments

Leave a Reply

Avatar placeholder

Your email address will not be published. Required fields are marked *